Dell Force10 TeraScale E Series - Page 71

BOOT_USER Mode | 71
Command
History
Example
Figure 4-7. show bootvar Command Example
Related
Commands
show default-gateway
c es
Display the IP address configured for the default gateway.
Syntax
show default-gateway
Command Mode
BOOT_USER
Command
History
Example
Figure 4-8. show default-gateway Command Example
Related
Commands
Version 7.8.1.0 Introduced on S-Series
BOOT_USER # show bootvar
PRIMARY OPERATING SYSTEM BOOT PARAMETERS:
========================================
boot device : ftp
file name : tt/latestlabel
Management Ethernet IP address : 10.16.1.181/24
Server IP address : 10.16.1.209
username : amsterdam
password : ******
SECONDARY OPERATING SYSTEM BOOT PARAMETERS:
==========================================
boot device : flash
file name : /E1200-3.1.1.3.bin
DEFAULT OPERATING SYSTEM BOOT PARAMETERS:
========================================
boot device : flash
file name : /E1200-3.1.1.2.bin
BOOT_USER #
boot change
Change the primary, secondary or default boot image configuration.
boot zero Erase the configured primary, secondary, or default boot image parameters.
Version 7.8.1.0 Introduced on S-Series
BOOT_USER # show default-gateway
Gateway IP address: 10.1.1.1
BOOT_USER #
default-gateway
Configure the IP address for the default gateway.
interface management ethernet ip address
Assign an IP address to the Management Ethernet
interface.