Dell Force10 TeraScale E Series - Page 63

BOOT_USER Mode | 63
Figure 4-3. Completed boot zero Command Example
Related
Commands
default-gateway
c es
Assign an IP address as the default gateway for the system.
Syntax
[no] default-gateway ip-address
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
Use the show default-gateway command to view the current default gateway.
Related
Commands
delete
c e
Erase a file on the internal or external Flash.
Syntax
delete file-url
Parameters
BOOT_USER # boot zero primary
BOOT_USER # boot zero secondary
BOOT_USER # boot zero default
BOOT_USER # show bootvar
PRIMARY OPERATING SYSTEM BOOT PARAMETERS:
========================================
No Operating System boot parameters specified!
SECONDARY OPERATING SYSTEM BOOT PARAMETERS:
==========================================
No Operating System boot parameters specified!
DEFAULT OPERATING SYSTEM BOOT PARAMETERS:
========================================
No Operating System boot parameters specified!
BOOT_USER #
boot change
Change the primary, secondary or default boot image configuration
show boot selection
Display the current Boot Flash image selected.
ip-address
Enter the IP address of the gateway router in dotted decimal format (A.B.C.D).
Version 7.8.1.0 Introduced on S-Series
show default-gateway Change the primary, secondary or default boot image configuration
show boot selection Display the current Boot Flash image selected.
file-url
Enter the location keywords and information:
• For a file on the internal Flash, enter
flash:// followed by the filename.
• For a file on the external Flash, enter
slot0:// followed by the filename.