72 | BOOT_USER Mode
www.dell.com | support.dell.com
show interface management ethernet
c es
Display the IP address configured for the Management interface.
Syntax
show interface management ethernet
Command Modes
BOOT_USER
Command
History
Example
Figure 4-9. show interface management ethernet Command Example
On the S-Series, the output of this command includes the MAC address and port number of the
assigned management port.
Example
Figure 4-10. show interface management ethernet Command Example
Related
Commands
Version 7.8.1.0 Introduced on S-Series
BOOT_USER # show interfaces management ethernet
Management ethernet IP address: 10.16.1.181/24
BOOT_USER #
BOOT_USER # show interface management ethernet
Management ethernet IP address: 10.16.1.181/24
Management ethernet MAC address: 00:01:e8:43:13:16
Management ethernet port number: 1
BOOT_USER #
interface management ethernet ip address
Assign an IP address to the Management Ethernet
interface.
interface management port config Configure speed, duplex, and negotiation settings for the
management interface.
To Next Page
Loading...
