Dell Force10 TeraScale E Series - Page 67

BOOT_USER Mode | 67
interface management ethernet mac-address
s
Assign a MAC address to the Management Ethernet interface.
Syntax
interface management ethernet mac-address mac-address
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
Use this command to assign a MAC address if FTOS cannot find a default MAC address.
Related
Commands
interface management ethernet port
s
Assign a port to be the Management Ethernet interface.
Syntax
interface management ethernet port portID
Parameters
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
Assign any copper port to be the Management Ethernet interface.
Related
Commands
interface management port config
c e
Configure speed, duplex, and negotiation settings for the management interface.
Syntax
interface management port config {half-duplex | full-duplex | 10m | 100m |
auto-negotiation | no auto-negotiation | show}
mac-address
Enter a MAC address in standard format (xx:xx:xx:xx:xx:xx).
Version 7.8.1.0 Introduced on S-Series
show default-gateway
Display the IP address configured for the default gateway.
show interface management
ethernet
Display the IP address configured for the Management interface.
portID
Enter an S-Series port ID as an integer.
Range: 1 to 48
Version 7.8.1.0 Introduced on S-Series
show interface management ethernet
Display the IP address configured for the Management
interface.