Dell Force10 TeraScale E Series - Page 65

BOOT_USER Mode | 65
Usage
Information
Only Dell Force10 TAC staff use this command.
format
c e
Format the internal or external flash memory.
Syntax
format file-url
Parameters
Defaults
Not configured.
Command Modes
BOOT_ADMIN
Usage
Information
The maximum number of files allowed on an MMC card (internal or external flash) is 100 files.
Related
Commands
ignore enable-password
c es
Reload the system software without the enable password configured. This command is hidden on the
C-Series and E-Series, so it is not listed when you enter ? or help in this mode.
Syntax
ignore enable-password
Defaults
Not configured.
Command Modes
BOOT_USER
Command
History
Usage
Information
When you enter the reload command and the system reboots, you will not be prompted for a password
to enter the EXEC Privilege mode (normally you are required to enter the enable command.)
If your console or Telnet session expires after you used the ignore enable-password command,
you are prompted for an enable password when you re-establish the session.
Related
Commands
file-url
Enter the location keywords and information:
• For a file on the internal Flash, enter
flash:// followed by the filename.
• For a file on the external Flash, enter
slot0:// followed by the filename.
format (C-Series and E-Series)
Erase all existing files and reformat a filesystem (EXEC Privilege
mode).
show file
Display contents of a text file in the local filesystem.
show file-systems
Display information about the file systems on the system.
Version 7.8.1.0 Introduced on S-Series
reload
Exit from this mode and reload FTOS.
show running-config Display the current configuration and the changes from the default values.