Dell Force10 TeraScale E Series - Page 1366

1366 | SNMP and Syslog
www.dell.com | support.dell.com
When multiple snmp-server host commands are given for the same host and type of notification
(trap or inform), each succeeding command overwrites the previous command. Only the last
snmp-server host command will be in effect. For example, if you enter an snmp-server host
inform command for a host and then enter another snmp-server host inform command for the
same host, the second command will replace the first.
The snmp-server host command is used in conjunction with the snmp-server enable command.
Use the snmp-server enable command to specify which SNMP notifications are sent globally. For a
host to receive most notifications, at least one snmp-server enable command and the
snmp-server host command for that host must be enabled.
Configuring Informs
To send an inform, follow the step below.
1. Configure a remote engine ID.
2. Configure a remote user.
3. Configure a group for this user with access rights.
4. Enable traps.
5. Configure a host to receive informs.
Related
Commands
snmp-server location
c e s
Configure the location of the SNMP server.
Syntax
snmp-server location text
To delete the SNMP location, enter no snmp-server location.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Note: For v1 / v2c trap configuration, if the community-string is not defined using the
snmp-server community command prior to using this command, the default form of the
snmp-server community command will automatically be configured, with the
community-name the same as specified in the snmp-server host command.
snmp-server enable traps Enable SNMP traps.
snmp-server community Configure a new community SNMPv1 or SNMPv2c
text
Enter an alpha-numeric text string, up to 55 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command