1040 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
show ip ospf database asbr-summary
c e s
Display information about AS Boundary LSAs.
Syntax
show ip ospf process-id database asbr-summary [link-state-id] [adv-router ip-address]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
Example
Figure 38-10. Command Example: show ip ospf database asbr-summary (Partial)
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
link-state-id
(OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID value depends
on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router
ip-address
(OPTIONAL) Enter the keywords
adv-router ip-address to display only the LSA
information about that router.
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
FTOS#show ip ospf 100 database asbr-summary
OSPF Router with ID (1.1.1.10) (Process ID 100)
Summary Asbr (Area 0.0.0.0)
LS age: 1437
Options: (No TOS-capability, No DC, E)
LS type: Summary Asbr
Link State ID: 103.1.50.1
Advertising Router: 1.1.1.10
LS Seq Number: 0x8000000f
Checksum: 0x8221
Length: 28
Network Mask: /0
TOS: 0 Metric: 2
LS age: 473
Options: (No TOS-capability, No DC, E)
LS type: Summary Asbr
Link State ID: 104.1.50.1
Advertising Router: 1.1.1.10
LS Seq Number: 0x80000010
Checksum: 0x4198
Length: 28
--More--
To Next Page
Loading...
