Dell Force10 TeraScale E Series - Page 1060

1060 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
This command can be used to isolate problems with inter-area and external routes. In OSPF inter-area
and external routes are calculated by adding LSA cost to the cost of reaching the router. If an inter-area
or external route is not of correct cost, the display can determine if the path to the originating router is
correct or not.
Example
Figure 38-21. Command Example: show ip ospf process-id topology
show ip ospf virtual-links
c e s
Display the OSPF virtual links configured and is useful for debugging OSPF routing operations. If no
OSPF virtual-links are enabled on the switch, no output is generated.
Syntax
show ip ospf process-id virtual-links
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a
specific OSPF process. If you do not enter the Process ID, only the first configured process is listed.
Example
Figure 38-22. Command Example: show ip ospf process-id virtual-links
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and E-Series
FTOS#show ip ospf 1 topology
Router ID Flags Cost Nexthop Interface Area
3.3.3.3 E/B/-/ 1 20.0.0.3 Gi 13/1 0
1.1.1.1 E/-/-/ 1 10.0.0.1 Gi 7/1 1
FTOS#
process-id
Enter the OSPF Process ID to show a specific process.
If no Process ID is entered, command applies only to the first OSPF process.
Version 7.8.1.0 Introduced support of Multi-Process OSPF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
FTOS#show ip ospf 1 virt
Virtual Link to router 192.168.253.5 is up
Run as demand circuit
Transit area 0.0.0.1, via interface GigabitEthernet 13/16, Cost of using 2
Transmit Delay is 1 sec, State POINT_TO_POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:02