Dell Force10 TeraScale E Series - Page 1076

1076 | Open Shortest Path First (OSPFv2 and OSPFv3)
www.dell.com | support.dell.com
Parameters
Default
Not configured.
Command Modes
ROUTER OSPFv3
Command
History
Usage
Information
To redistribute the default route (x:x:x:x::x), configure the default-information originate command.
Related
Commands
router-id
c e
Designate a fixed router ID.
Syntax
router-id ip-address
To return to the previous router ID, use the no router-id ip-address command.
Parameters
Defaults
The router ID is selected automatically from the set of IPv4 addresses configured on a router
Command Modes
ROUTER OSPF
bgp as number Enter the keyword bgp followed by the autonomous system number.
Range: 1 to 65535
connected Enter the keyword connected to redistribute routes from physically
connected interfaces.
static Enter the keyword static redistribute manually configured routes.
metric metric-value
Enter the keyword metric followed by the metric value.
Range: 0 to 16777214
Default: 20
metric-type
type-value
(OPTIONAL) Enter the keyword metric-type followed by the OSPFv3 link
state type of 1 or 2 for default routes. The values are:
1 = Type 1 external route
2 = Type 2 external route
Default: 2
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an
established route map. If the route map is not configured, the default is deny (to
drop all routes).
tag tag-value (OPTIONAL) Enter the keyword tag to set the tag for routes redistributed into
OSPFv3.
Range: 0 to 4294967295
Default: 0
Version 7.8.1.0 Added support for C-Series
Version 7.4.1.0 Introduced
default-information originate Configure default external route into OSPFv3
ip-address
Enter the router ID in the dotted decimal format.