Policy-based Routing (PBR) | 1091
Defaults
No default behavior or values
Command Modes
REDIRECT-LIST
Command
History
bit
(OPTIONAL) For TCP protocol type only, enter one or a combination of the
following TCP flags:
•
ack = acknowledgement
•
fin = finish (no more data from the user)
•
psh = push function
•
rst = reset the connection
•
syn = synchronize sequence number
•
urg = urgent field
operator
(OPTIONAL) For TCP and UDP parameters only. Enter one of the
following logical operand:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt = less than
•
range = inclusive range of ports (you must specify two ports for the
port command parameter.)
Version 8.4.2.1 Introduced on the C-Series and S-Series
Version 8.4.2.0 Introduced on the E-Series TeraScale
Version 7.5.1.0 Added the bit variable and Permit and Redirect
Version 6.5.3.0 Introduced on the E-Series ExaScale
To Next Page