Dell Force10 TeraScale E Series - Page 110

110 | Control and Monitoring
www.dell.com | support.dell.com
Examples
Figure 5-16. Command Example: show environment for the E1200
Figure 5-17. Command Example: show environment fan on the E600
FTOS#show environment
-- Fan Status --
Tray Status Temp Volt Speed PEM0 PEM1 Fan1 Fan2 Fan3
--------------------------------------------------------------------------------
0 up < 50C 12-16V low/2100-2700 RPM up up up up up
1 up < 50C 12-16V low/2100-2700 RPM up up up up up
2 up < 50C 12-16V low/2100-2700 RPM up up up up up
3 up < 50C 12-16V low/2100-2700 RPM up up up up up
4 up < 50C 16-20V med/2700-3200 RPM up up up up up
5 up < 50C 12-16V low/2100-2700 RPM up up up up up
-- Power Entry Modules --
Bay Status
---------------------------------------------------------------------------
0 absent or down
1 up
-- Line Card Environment Status --
Slot Status Temp PEM0 PEM1 Voltage
---------------------------------------------------------------------------
0 not present
1 not present
2 not present
3 not present
4 not present
5 not present
6 not present
7 not present
8 not present
9 not present
10 not present
11 booting 53C down up ok
12 not present
13 not present
-- RPM Environment Status --
Slot Status Temp PEM0 PEM1 Voltage
---------------------------------------------------------------------------
0 active 48C down up ok
1 not present
-- SFM Environment Status --
Slot Status Temp PEM0 PEM1
---------------------------------------------------------------------------
0 active 49C up up
1 active 47C up up
2 active 46C up up
3 active 48C up up
4 active 52C up up
5 active 50C up up
6 active 47C up up
7 active 48C up up
8 active 47C up up
FTOS#
FTOS#show environment fan
-- Fan Status --
Status Temp Fan1 Fan2 Fan3 Serial Num Version
------------------------------------------------------------------
up 29C 6000 RPM 7500 RPM 7500 RPM 0.0
FTOS#