PIM-Sparse Mode (PIM-SM) | 1117
show ip pim summary
c e s
View information about PIM-SM operation.
Syntax
show ip pim summary
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 41-11. show ip pim summary Command Example
Version 8.4.1.1 Support for the display of PIM-SM snooping status was added on E-Series
ExaScale
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Introduced on S-Series
FTOS#show ip pim summary
PIM TIB version 495
Uptime 22:44:52
Entries in PIM-TIB/MFC : 2/2
Active Modes :
PIM-SNOOPING
Interface summary:
1 active PIM interface
0 passive PIM interfaces
3 active PIM neighbors
TIB summary:
1/1 (*,G) entries in PIM-TIB/MFC
1/1 (S,G) entries in PIM-TIB/MFC
0/0 (S,G,Rpt) entries in PIM-TIB/MFC
0 PIM nexthops
0 RPs
0 sources
0 Register states
Message summary:
2582/2583 Joins sent/received
5/0 Prunes sent/received
0/0 Candidate-RP advertisements sent/received
0/0 BSR messages sent/received
0/0 State-Refresh messages sent/received
0/0 MSDP updates sent/received
0/0 Null Register messages sent/received
0/0 Register-stop messages sent/received
Data path event summary:
0 no-cache messages received
0 last-hop switchover messages received
0/0 pim-assert messages sent/received
0/0 register messages sent/received
Memory usage:
TIB : 3768 bytes
Nexthop cache : 0 bytes
Interface table : 992 bytes
Neighbor table : 528 bytes
RP Mapping : 0 bytes
To Next Page