PIM-Sparse Mode (PIM-SM) | 1119
show running-config pim
e
x
Display the current configuration of PIM-SM snooping.
Syntax
show running-config pim
Command Modes
EXEC Privilege
Command
History
Related
Commands
Example
Command Example: show running-config pim
flags List the flags to define the entries:
• D = PIM Dense Mode
• S = PIM Sparse Mode
• C = directly connected
• L = local to the multicast group
• P = route was pruned
• R = the forwarding entry is pointing toward the RP
• F = FTOS is registering this entry for a multicast source
• T = packets were received via Shortest Tree Path
• J = first packet from the last hop router is received and the entry is
ready to switch to SPT
• K = acknowledge pending state
Incoming interface Displays the reverse path forwarding (RPF) interface towards the RP/
source.
RPF neighbor Displays the next hop from this interface towards the RP/source.
Outgoing interface list: Lists the interfaces that meet one of the following criteria:
• a directly connect member of the Group.
• statically configured member of the Group.
• received a (*,G) Join message.
Table 41-6. show ip pim tib Command Example Fields (continued)
Field Description
Version 8.4.1.0 Introduced on E-Series ExaScale.
ip pim snooping Enable PIM-SM snooping.
FTOS#show running-config pim
!
ip pim snooping enable
To Next Page