Dell Force10 TeraScale E Series - Page 112

112 | Control and Monitoring
www.dell.com | support.dell.com
Example
Figure 5-19. Command Example: show environment all on the S-Series
Example
Figure 5-20. Command Example: show environment fan on the S-Series
Example
Figure 5-21. Command Example: show environment pem on the S-Series
Example
Figure 5-22. Command Example: show environment stack-unit on the S-Series
FTOS#show environment all
-- Fan Status --
--------------------------------------------------------------------------------
Unit TrayStatus Fan0 Fan1 Fan2 Fan3 Fan4 Fan5
0 up up up up up up up
-- Power Supplies --
Unit Bay Status Type
---------------------------------------------------------------------------
0 0 up AC
0 1 absent
-- Unit Environment Status --
Unit Status Temp Voltage
---------------------------------------------------------------------------
0* online 50C ok
* Management Unit
-- Fan Status --
Unit Status Speed Fan1 Fan2 Fan3 Fan4 Fan5 Fan6 Serial Num Version
--------------------------------------------------------------------------------
1 up high up up up up up up 1234 1
FTOS#show environment fan
-- Fan Status --
--------------------------------------------------------------------------------
Unit TrayStatus Fan0 Fan1 Fan2 Fan3 Fan4 Fan5
0 up up up up up up up
FTOS#show environment pem
-- Power Supplies --
Unit Bay Status Type
---------------------------------------------------------------------------
0 0 up AC
0 1 absent
FTOS#show environment stack-unit 0
-- Unit Environment Status --
Unit Status Temp Voltage
---------------------------------------------------------------------------
0* online 49C ok
* Management Unit