1122 | PIM-Sparse Mode (PIM-SM)
www.dell.com | support.dell.com
Parameters
Defaults
As above
Command Modes
CONFIGURATION
Command
History
ipv6 pim dr-priority
e
Change the Designated Router (DR) priority for the IPv6 interface.
Syntax
ipv6 pim dr-priority priority-value
To remove the DR priority value assigned, use the no ipv6 pim dr-priority command.
Parameters
Defaults
1
Command Modes
INTERFACE
Command
History
Usage
Information
The router with the largest value assigned to an interface becomes the Designated Router. If two
interfaces contain the same DR priority value, the interface with the largest interface IP address
becomes the Designated Router.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
hash-mask-length
(OPTIONAL) Enter the hash mask length for RP selection.
Range: 0 to 128
Default: 126
priority
(OPTIONAL) Enter the priority value for Bootstrap election process.
Range: 0 to 255
Default: 0
Version 7.4.1.0 Introduced
priority-value Enter a number. Preference is given to larger/higher number.
Range: 0 to 4294967294
Default: 1
Version 7.4.1.0 Introduced
To Next Page
Loading...
