Dell Force10 TeraScale E Series - Page 1139

Power over Ethernet (PoE) | 1139
Example
FTOS(conf-if-range-gi-0/1-48)#do show power inline
Interface Admin Inline Power Inline Power Class User
Allocated Consumed Priority
(Watts) (Watts)
--------- ----- ------------ ------------ ----- ----------
Gi 0/1 auto 0.00 0.00 NO_DEVICE Low
Gi 0/2 auto 7.00 3.20 2 Low
Related
Commands
show power supply
c s
Display the power supply status.
Syntax
show power supply
Command Modes
EXEC
EXEC Privilege
Command
History
C-Series
Example
Figure 43-1. show power supply (C-Series) Command Example
Table 43-2. show power inline Command Output Field Description
Interface Displays the line card slot and port number.
Admin Displays the PoE mode of the port. The mode can be either auto or static. See
power budget.
Inline Power Allocated Displays the amount of power allocated to the port.
Inline Power Consumed Displays the amount of power that is consumed by the connected device.
Class Displays the power classification of the connected device. Valid classes are
0-4.
User Priority Displays the power configured by the user for the port (default is low). See
power inline priority.
power inline Enable power to be supplied to a device connected to a port.
power inline priority Set the PoE priority of the selected port
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
FTOS#show power supply
Power Model
Supply Number Type Status
---------------------------------------------------------------------
PEM0 Absent
PEM1 Absent
PEM2 CC-C-1200W-AC AC Active
PEM3 Absent
PEM4 CC-C-1200W-AC AC Powered Off
PEM5 CC-C-1200W-AC AC Active
FTOS#