Port Monitoring | 1143
flow-based enable
e
Enable flow-based monitoring.
Syntax
flow-based enable
To disable flow-based monitoring, use the no flow-based enable command.
Defaults
Disabled, that is flow-based monitoring is not applied
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
History
Usage
Information
To monitoring traffic with particular flows ingressing/egressing the interface, appropriate ACLs can be
applied in both ingress and egress direction.
Related
Commands
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series
monitor session Create a monitoring session.
To Next Page