Dell Force10 TeraScale E Series - Page 1147

Port Monitoring | 1147
show monitor session
c e s
Display the monitor information of a particular session or all sessions.
Syntax
show monitor session {session-ID}
To display monitoring information for all sessions, use the show monitor session command.
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Example
Figure 44-3. Commands Example: show monitor session
Related
Commands
session-ID
(OPTIONAL) Enter a session identification number.
Range: 0 to 65535
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
FTOS#show monitor session 11
SessionID Source Destination Direction Mode Type
--------- ------ ------------- --------- ------- ----------
11 Gi 10/0 Gi 10/47 rx interface Port-based
12 Po 1 remote-vlan 12 both Remote-Port-Mirroring Port-based
monitor session Create a session for monitoring.