Dell Force10 TeraScale E Series - Page 1238

1238 | Router Information Protocol (RIP)
www.dell.com | support.dell.com
Defaults
Disabled.
metric: 1
Command Modes
ROUTER RIP
Command
History
Usage
Information
The default route must be present in the switch routing table for the default-information originate
command to take effect.
default-metric
c e s
Change the default metric for routes. Use this command with the redistribute command to ensure
that all redistributed routes use the same metric value.
Syntax
default-metric number
To return the default metric to the original values, enter no default-metric.
Parameters
Default
1
Command Modes
ROUTER RIP
Command
History
Usage
Information
This command ensures that route information being redistributed is converted to the same metric value.
Related
Commands
description
c e s
Enter a description of the RIP routing protocol
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
number
Specify a number.
Range: 1 to 16.
The default is 1.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
redistribute Allows you to redistribute routes learned by other methods.
description
Enter a description to identify the RIP protocol (80 characters maximum).