Dell Force10 TeraScale E Series - Page 1243

Router Information Protocol (RIP) | 1243
Defaults
Enabled
Command Modes
INTERFACE
Command
History
Related
Commands
maximum-paths
c e s
Set RIP to forward packets over multiple paths.
Syntax
maximum-paths number
To return to the default values, enter no maximum-paths.
Parameters
Defaults
4
Command Modes
ROUTER RIP
Command
History
Usage
Information
RIP supports a maximum of 16 ECMP paths.
neighbor
c e s
Define a neighbor router with which to exchange RIP information.
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip poison-reverse Set the prefix for RIP routing updates.
number
Enter the number of paths.
Range: 1 to 16.
The default is 4 paths.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip-address
Enter the IP address, in dotted decimal format, of a router with which to exchange
information.