Dell Force10 TeraScale E Series - Page 1248

1248 | Router Information Protocol (RIP)
www.dell.com | support.dell.com
Usage
Information
IS-IS is not supported on S-Series systems.
redistribute ospf
c e s
Redistribute routing information from an OSPF process.
Syntax
redistribute ospf process-id [match external {1 | 2} | match internal | metric metric-value]
[route-map map-name]
To disable redistribution, enter no redistribute ospf process-id [match external {1 | 2} | match
internal | metric metric-value] [route-map map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
router rip
c e s
Enter the ROUTER RIP mode to configure and enable RIP.
Syntax
router rip
To disable RIP, enter no router rip.
Defaults
Disabled.
Command Modes
CONFIGURATION
Command
History
process-id
Enter a number that corresponds to the OSPF process ID to be redistributed.
Range: 1 to 65355.
match external {1
|
2}
(OPTIONAL) Enter the keywords
match external followed by the numbers 1
or 2 to indicated that external 1 routes or external 2 routes should be redistributed.
match internal (OPTIONAL) Enter the keywords match internal to indicate that internal
routes should be redistributed.
metric
metric-value
(OPTIONAL) Enter the keyword
metric followed by a number as the metric
value.
Range: 0 to16
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of a
configured route map.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series