Dell Force10 TeraScale E Series - Page 1267

Rapid Spanning Tree Protocol (RSTP) | 1267
Example
Figure 50-1. debug spanning-tree rstp bpdu Command Example
description
c e s
Enter a description of the Rapid Spanning Tree
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
SPANNING TREE (The prompt is “config-rstp”.)
Command
History
Related
Commands
disable
c e s
Disable RSTP globally on the system.
Syntax
disable
To enable Rapid Spanning Tree Protocol, enter no disable.
Defaults
RSTP is disabled
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Related
Commands
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced for E-Series
FTOS#debug spanning-tree rstp bpdu gigabitethernet 2/0 ?
in Receive (in)
out Transmit (out)
description
Enter a description to identify the Rapid Spanning Tree (80 characters maximum).
pre-7.7.1.0 Introduced
protocol spanning-tree rstp Enter SPANNING TREE mode on the switch.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced for E-Series
protocol spanning-tree rstp Enter the Rapid Spanning Tree mode