Security | 1287
access-class
c e s
Restrict incoming connections to a particular IP address in a defined IP access control list (ACL).
Syntax
access-class access-list-name
To delete a setting, use the no access-class command.
Parameters
Defaults
Not configured.
Command Modes
LINE
Command
History
Related
Commands
enable password
c e s
Change the password for the enable command.
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type] password [level level]
command.
Parameters
Defaults
No password is configured. level = 15
Command Modes
CONFIGURATION
Command
History
access-list-name
Enter the name of an established IP Standard ACL.
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.2.1.1 Introduced on E-Series
line Apply an authentication method list to designated terminal lines.
ip access-list standard Name (or select) a standard access list to filter based on IP address.
ip access-list extended Name (or select) an extended access list based on IP addresses or protocols.
level level (OPTIONAL) Enter the keyword level followed by a number as the level of
access.
Range: 1 to 15
encryption-type (OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a
7 followed by a text string as the hidden password. The text string must
be a password that was already encrypted by a Dell Force10 router.
Use this parameter only with a password that you copied from the
show
running-config file of another Dell Force10 router.
password
Enter a text string, up to 32 characters long, as the clear text password.
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
To Next Page
Loading...
