Dell Force10 TeraScale E Series - Page 1301

Security | 1301
Parameters
Defaults
Not configured.
Command Mode
CONFIGURATION
Command
History
tacacs-server host
c e s
Specify a TACACS+ host.
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address} [port number] [timeout
seconds] [key key]
Parameters
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a number
from zero (0) to 16838.
• For the Null interface, enter the keywords
null 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.2.1.1 Introduced on E-Series
hostname
Enter the name of the TACACS+ server host.
ipv4-address |
ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X), of the
TACACS+ server host.
port number (OPTIONAL) Enter the keyword port followed by a number as the port to be
used by the TACACS+ server.
Range: zero (0) to 65535
Default: 49