Dell Force10 TeraScale E Series - Page 1380

1380 | SNMP and Syslog
www.dell.com | support.dell.com
logging trap
c e s
Specify which messages are logged to the Syslog server based the message severity.
Syntax
logging trap [level]
To return to the default values, enter default logging trap. To disable logging, enter no logging
trap.
Parameters
Defaults
6 or informational
Command Modes
CONFIGURATION
Command
History
Related
Commands
show logging
c e s
Display the logging settings and system messages logged to the internal buffer of the switch.
Syntax
show logging [number | history [reverse] [number] | reverse [number] | summary]
Parameters
Command Modes
EXEC
EXEC Privilege
level
Indicate a value from 0 to 7 or enter one of the following parameters: emergencies, alerts,
critical, errors, warnings, notifications, informational, or debugging.
The default is 6.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging Enable the logging to another device.
logging on Enables logging.
number
(OPTIONAL) Enter the number of message to be displayed on the output.
Range: 1 to 65535
history (OPTIONAL) Enter the keyword history to view only information in the Syslog history
table.
reverse (OPTIONAL) Enter the keyword reverse to view the Syslog messages in FIFO (first in,
first out) order.
summary (OPTIONAL) Enter the keyword summary to view a table showing the number of
messages per type and per slot.
Slots *7* and *8* represent RPMs.