140 | Control and Monitoring
www.dell.com | support.dell.com
show processes switch-utilization
e
Show switch fabric utilization.
Syntax
show processes switch-utilization
Command Mode
EXEC
EXEC Privilege
Command
History
Example
Figure 5-52. Command Example: show processes switch-utilization
Usage
Information
An asterisk ( * ) in the output indicates a legacy card that is not support by the show processes
switch-utilization command.
show rpm
c e
Show the current RPM status.
Syntax
show rpm [number [brief] | all]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.1.1.0 Introduced on E-Series ExaScale
E-Series original Command
FTOS#show processes switch-utilization
Switch fabric utilization 5Sec 1Min 5Min
------------------------------------------------------
3% 3% 3%
number
(OPTIONAL) Enter either zero (0) or 1 for the RPM.
all (OPTIONAL) Enter the keyword all to view a table with information on all present RPMs.
brief (OPTIONAL) Enter the keyword brief to view an abbreviated list of RPM information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
To Next Page
Loading...
