Dell Force10 TeraScale E Series - Page 1412

1412 | Storm Control
www.dell.com | support.dell.com
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Example
E-Series
Figure 57-4. show storm-control unknown-unicast Command Example (E-Series)
Example
C-Series
Figure 57-5. show storm-control unknown-unicast Command Example (C-Series)
storm-control broadcast (Configuration)
c e s
Configure the percentage of broadcast traffic allowed in or out of the network.
Syntax
storm-control broadcast [percentage decimal_value in | out] | [wred-profile name]]
[packets_per_second in]
To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value
in | out] | [wred-profile name]] [packets_per_second in] command.
interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• Fast Ethernet is not supported.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.10 Introduced on C-Series
Version 6.5.1.0 Introduced on E-Series
FTOS#show storm-control unknown-unicast gigabitethernet 11/1
Unknown-unicast storm control configuration
Interface Direction Percentage Wred Profile
--------------------------------------------------------------
Gi 11/1 Ingress 5.9 -
Gi 11/1 Egress 5.7 w8
FTOS#
FTOS#show storm-control unknown-unicast gigabitethernet 3/0
Unknown-unicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------------
Gi 3/0 Ingress 1000
FTOS#