Virtual Router Redundancy Protocol (VRRP) | 1491
show vrrp ipv6
e c s
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the FTOS returns “No
Active VRRP group
.”
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Figure 63-5. Command Example: show vrrp ipv6
vrid
(OPTIONAL) Enter the Virtual Router Identifier for the VRRP group to view only that
group.
Range: 1 to 255.
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by
the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed by a number:
E-Series Range: 1 to 255 for TeraScale
• For SONET interfaces, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLAN
ID range is from 1 to 4094.
brief
(OPTIONAL) Enter the keyword brief to view a table of information on the VRRP groups
on the E-Series.
Version 8.3.2.0 Introduced
Table 63-3. Command Example Description: show vrrp ipv6
Line Beginning with Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network address.
If the interface is no sending VRRP packets,
0.0.0.0 appears as the network
address.
VRF VRF instance to which the interface (on which the VRRP group is configured) belongs
FTOS#show vrrp ipv6
------------------
GigabitEthernet 5/6, IPv6 VRID: 255, Version: 3, Net:
fe80::201:e8ff:fe7a:6bb9
VRF: 0 default-vrf
State: Master, Priority: 101, Master: fe80::201:e8ff:fe7a:6bb9 (local)
Hold Down: 0 centisec, Preempt: TRUE, AdvInt: 100 centisec
Accept Mode: FALSE, Master AdvInt: 100 centisec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 64
Virtual MAC address:
00:00:5e:00:02:ff
Virtual IP address:
1::255 fe80::255
To Next Page
Loading...
