EasyManua.ls Logo

Dell Force10 TeraScale E Series - Page 1493

Dell Force10 TeraScale E Series
1640 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Virtual Router Redundancy Protocol (VRRP) | 1493
vrrp-ipv6-group
e c s
Assign an interface to a VRRP group.
Syntax
vrrp-ipv6-group vrid
Parameters
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a link-local virtual IP address is
configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.
E-Series ExaScale and TeraScale only: Starting in release 8.4.2.1, you can configure up to 255
VRRP groups per interface if VRF microcode is not loaded, and up to 15 groups if VRF microcode is
loaded.
E-Series ExaScale and TeraScale only: Starting in release 8.4.2.1, the VRID used by the VRRP
protocol changes according to whether VRF microcode is loaded or not:
When VRF microcode is not loaded in CAM, the VRID for a VRRP group is the same as the
VRID number configured with the vrrp-group or vrrp-ipv6-group command.
When VRF microcode is loaded in CAM, the VRID for a VRRP group is equal to 16 times the
vrrp-group or vrrp-ipv6-group vrid number plus the ip vrf vrf-id number.
For example, if VRF microcode is loaded and VRRP group 10 is configured in VRF 2, the VRID
used for the VRRP group is (16 x 10) + 2, or 162. This VRID value is used in the lowest byte of
the virtual MAC address of the VRRP group and is also used for VRF routing.
Important: You must configure the same VRID on neighboring routers (Dell Force10 or non-Dell
Force10) in the same VRRP group in order for all routers to interoperate.
Related
Commands
vrid
Enter the virtual-router ID number of the VRRP group.
VRID range (C-Series and S-Series): 1-255.
VRID range (E-Series): 1-255 when VRF microcode is not loaded and 1-15 when VRF
microcode is loaded.
Version 8.4.2.1 The range of valid VRID values on the E-Series when VRF microcode is loaded in
CAM changed to 1-15.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Version 8.3.2.0 Introduced on E-Series TeraScale
virtual-address Assign up to 12 virtual IP addresses per VRRP group.

Table of Contents

Related product manuals