Dell Force10 TeraScale E Series - Page 1526

1526 | C-Series Diagnostics and Debugging
www.dell.com | support.dell.com
offline
c
Place a line card or SFM in an offline state.
Syntax
offline {linecard number | sfm standby}
Parameters
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
History
H
Usage
Information
online
c
Place a linecard or RPM in an online state.
Syntax
online {linecard number | sfm standby}
Parameters
Defaults
None
Command Mode
EXEC
EXEC Privilege
Command
History
H
Usage
Information
linecard Enter the keyword linecard to place the linecard in an offline
state.
sfm standby Enter the keywords sfm standby to place the RPM in an offline
state.
number After the keyword linecard:
Range: 0-7 for the C300
Version 7.5.1.0 Introduction
Warning: Do not use this command when a line card is in a booting state.
linecard Enter the keyword linecard to place the linecard in an online state.
sfm standby Enter the keywords sfm standby to place the RPM in an online state.
number After the keyword linecard:
Range: 0-7 for the C300; 0-3 for the C150
Version 7.5.1.0 Introduction
Warning: Do not use this command when a line card is in a booting state.