Dell Force10 TeraScale E Series - Page 1598

1598 | SNMP Traps
www.dell.com | support.dell.com
%CHMGR-5-CPU_THRESHOLD_CLR: Cpu %s usage drops below threshold. Cpu5SecUsage (%d)
CHM_MEM_THRESHOLD ENVMON NONE
%CHMGR-5-MEM_THRESHOLD: Memory %s usage above threshold. MemUsage (%d)
CHM_MEM_THRESHOLD_CLR ENVMON NONE
%CHMGR-5-MEM_THRESHOLD_CLR: Memory %s usage drops below threshold. MemUsage (%d)
MACMGR_STN_MOVE ENVMON NONE
%MACMGR-5-DETECT_STN_MOVE: Station Move threshold exceeded for Mac %s in vlan %d
VRRP_BADAUTH PROTO NONE
%RPM1-P:RP2 %VRRP-3-VRRP_BAD_AUTH: vrid-1 on Gi 11/12 rcvd pkt with authentication type mismatch.
%RPM1-P:RP2 %VRRP-3-VRRP_BAD_AUTH: vrid-1 on Gi 11/12 rcvd pkt with authentication failure.
VRRP_GO_MASTER PROTO NONE
%VRRP-6-VRRP_MASTER: vrid-%d on %s entering MASTER
BGP4_ESTABLISHED PROTO NONE
%TRAP-5-PEER_ESTABLISHED: Neighbor %a, state %s
BGP4_BACKW_XSITION PROTO NONE
%TRAP-5-BACKWARD_STATE_TRANS: Neighbor %a, state %s
Table B-1. SNMP Traps and Error Messages (continued)
Message ID Trap Type Trap Option