Dell Force10 TeraScale E Series - Page 169

802.1ag | 169
Command
History
mep cross-check
s
Enable cross-checking for an MEP.
Syntax
mep cross-check mep-id
Parameters
Defaults
None
Command Modes
ECFM DOMAIN
Command
History
mep cross-check enable
s
Enable cross-checking.
Syntax
mep cross-check enable {port | vlan-id}
Parameters
Defaults
None
Command Modes
ECFM DOMAIN
Command
History
mep cross-check start-delay
s
Configure the amount of time the system waits for a remote MEP to come up before the cross-check
operation is started.
Syntax
mep cross-check start-delay number
Parameters
Defaults
3 ccms
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on S-Series
mep-id
Enter the MEP ID
Range: 1-8191
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on S-Series
port
Down service with no VLAN association.
vlan-id
Enter the VLAN to apply the cross-check.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on S-Series
start-delay number
Enter a start-delay in seconds.
Range: 3-100 seconds