Dell Force10 TeraScale E Series - Page 186

186 | 802.3ah
www.dell.com | support.dell.com
show ethernet oam status
s
Display Link Layer OAM status per interface.
Syntax show ethernet oam status interface interface
Parameters
Defaults
None
Command Mode
EXEC Privilege
Command
History
Example
FTOS# show ethernet oam status interface <interface-name>
Output Format :
<interface-name>
General
______
Mode:active
PDU max rate:10 packets per second
PDU min rate:1 packet per second
Link timeout:5 seconds
High threshold action:no action
Link Monitoring
____________
Status supported (on)
Symbol Period Error
Window:1 million symbols
Low threshold:1 error symbol(s)
High threshold:none
Frame Error
Window:1 million symbols
Low threshold:1 error symbol(s)
High threshold:none
Frame Period Error
Window:1 x 100,000 frames
Low threshold:1 error symbol(s)
High threshold:none
Frame Seconds Error
Window:600 x 100 milliseconds
Low threshold:1 error second(s)
High threshold:none
interface Enter the interface for which you want to display status, for example gig 0/1.
Version 8.4.1.0 Introduced on S-Series