Dell Force10 TeraScale E Series - Page 195

802.1X | 195
dot1x max-eap-req
c e s
Configure the maximum number of times an EAP (Extensive Authentication Protocol) request is
transmitted before the session times out.
Syntax
dot1x max-eap-req number
To return to the default, use the no dot1x max-eap-req command.
Parameters
Defaults
2
Command Modes
INTERFACE
Command
History
dot1x max-supplicants
c e
t
s
Restrict the number of supplicants that can be authenticated and permitted to access the network
through the port. This configuration is only takes effect in multi-auth mode.
Syntax
dot1x max-supplicants number
Parameters
Defaults
128 hosts can be authenticated on a single authenticator port.
Command Modes
INTERFACE
Command
History
Related
Commands
dot1x port-control
c e s
Enable port control on an interface.
Syntax
dot1x port-control {force-authorized | auto | force-unauthorized}
number
Enter the number of times an EAP request is transmitted before a session time-out.
Range: 1 to 10
Default: 2
Version 7.6.1.0 Introduced on C-Series and S-Series
Version 7.4.1.0 Introduced on E-Series
number
Enter the number of supplicants that can be authenticated on a single port in
multi-auth mode.
Range: 1-128
Default: 128
Version 8.4.1.0 Introduced on C-Series and S-Series
dot1x host-mode