Dell Force10 TeraScale E Series - Page 203

802.1X | 203
Figure 8-4. show dot1x interface (with Multi-Supplicant Authentication enabled)
Example
FTOS#show dot1x interface g 0/21
802.1x information on Gi 0/21:
-----------------------------
Dot1x Status: Enable
Port Control: AUTO
Re-Authentication: Disable
Guest VLAN: Enable
Guest VLAN id: 100
Auth-Fail VLAN: Disable
Auth-Fail VLAN id: NONE
Auth-Fail Max-Attempts: NONE
Mac-Auth-Bypass: Disable
Mac-Auth-Bypass Only: Disable
Tx Period: 30 seconds
Quiet Period: 60 seconds
ReAuth Max: 3
Supplicant Timeout: 30 seconds
Server Timeout: 30 seconds
Re-Auth Interval: 60 seconds
Max-EAP-Req: 2
Host Mode: MULTI_AUTH
Max-Supplicants: 128
Port status and State info for Supplicant: 00:00:00:00:00:10
Port Auth Status: AUTHORIZED
Untagged VLAN id: 400
Auth PAE State: Authenticated
Backend State: Idle
Port status and State info for Supplicant: 00:00:00:00:00:11
Port Auth Status: AUTHORIZED
Untagged VLAN id: 300
Auth PAE State: Authenticated
Backend State: Idle
Port status and State info for Supplicant: 00:00:00:00:00:15
Port Auth Status: AUTHORIZED(GUEST-VLAN)
Untagged VLAN id: 100
Auth PAE State: Authenticated
Backend State: Idle