Dell Force10 TeraScale E Series - Page 271

Access Control Lists (ACL) | 271
Parameters
Defaults
No default behavior or values
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match as-path
c e s
Configure a filter to match routes that have a certain AS number in their BGP path.
Syntax
match as-path as-path-name
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match community
c e s
Configure a filter to match routes that have a certain COMMUNITY attribute in their BGP path.
Syntax
match community community-list-name [exact]
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
description
Enter a description to identify the route map (80 characters maximum).
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 7.7.1.0 Introduced
route-map Enable a route map
as-path-name
Enter the name of an established AS-PATH ACL, up to 140 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
set as-path Add information to the BGP AS_PATH attribute.
community-list-name
Enter the name of a configured community list.
exact (OPTIONAL) Enter the keywords exact to process only those routes with this
community list name.