Dell Force10 TeraScale E Series - Page 281

Access Control Lists (ACL) | 281
set level
c e s
Configure a filter to specify the IS-IS level or OSPF area to which matched routes are redistributed.
Syntax
set level {backbone | level-1 | level-1-2 | level-2 | stub-area}
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
set local-preference
c e s
Configure a filter to set the BGP LOCAL_PREF attribute for routers within the local autonomous
system.
Syntax
set local-preference value
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
backbone Enter the keyword backbone to redistribute matched routes to the OSPF backbone area
(area 0.0.0.0).
level-1 Enter the keyword level-1 to redistribute matched routes to IS-IS Level 1.
level-1-2 Enter the keyword level-1-2 to redistribute matched routes to IS-IS Level 1 and Level 2.
level-2 Enter the keyword level-2 to redistribute matched routes to IS-IS Level 2.
stub-area Enter the keyword stub to redistributed matched routes to OSPF stub areas.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
set automatic-tag Compute the tag value of the route.
set metric Specify the metric value assigned to redistributed routes.
set metric-type Specify the metric type assigned to redistributed routes.
set tag Specify the tag assigned to redistributed routes.
value
Enter a number as the LOCAL_PREF attribute value.
Range: 0 to 4294967295
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series