Dell Force10 TeraScale E Series - Page 338

338 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Usage
Information
Enter no debug ip bgp command to remove all configured debug commands for BGP.
Command
History
debug ip bgp notifications
c e s
Enables you to view information about BGP notifications received from neighbors.
Syntax
debug ip bgp [ip-address | peer-group peer-group-name] notifications [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name]
notifications [in | out] command.
Parameters
Command Modes
EXEC Privilege
Usage
Information
Enter no debug ip bgp command to remove all configured debug commands for BGP.
Command
History
debug ip bgp ipv4 unicast soft-reconfiguration
c e s
Enable soft-reconfiguration debugging for IPv4 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv4 unicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address |
peer-group-name] ipv4 unicast soft-reconfiguration command.
Parameters
Defaults
Disabled
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group
peer-group-name
(OPTIONAL) Enter the keyword peer-group followed by the name of the
peer group.
in (OPTIONAL) Enter the keyword in to view BGP notifications received from
neighbors.
out (OPTIONAL) Enter the keyword out to view BGP notifications sent to
neighbors.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ipv4-address |
ipv6-address
Enter the IP address of the neighbor on which you want to enable
soft-reconfiguration debugging.
peer-group-name
Enter the name of the peer group on which you want to enable soft-reconfiguration
debugging.
ipv4 unicast
Debug soft reconfiguration for IPv4 unicast routes.