Dell Force10 TeraScale E Series - Page 340

340 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Defaults
0
Command Modes
ROUTER BGP
Usage
Information
The default-metric command in BGP sets the value of the BGP MULTI_EXIT_DISC (MED) attribute
for redistributed routes only.
Related
Commands
Command
History
description
c e s
Enter a description of the BGP routing protocol.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
ROUTER BGP
Command
History
Related
Commands
distance bgp
c e s
Configure three administrative distances for routes.
Syntax
distance bgp external-distance internal-distance local-distance
To return to default values, enter no distance bgp.
bgp always-compare-med Enable comparison of all BGP MED attributes.
redistribute Redistribute routes from other routing protocols into BGP.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
description
Enter a description to identify the BGP protocol (80 characters maximum).
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
pre-7.7.1.0 Introduced
router bgp Enter ROUTER mode on the switch.