Dell Force10 TeraScale E Series - Page 342

342 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Command
History
neighbor activate
c e s
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI
(Address Family Identifier/Subsequent Address Family Identifier).
Syntax
neighbor [ip-address | peer-group-name] activate
To disable, use the no neighbor [ip-address | peer-group-name] activate command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Usage
Information
By default, when a neighbor/peer group configuration is created in the Router BGP context, it is
enabled for the IPv4/Unicast AFI/SAFI. By using activate in the new context, the neighbor/peer
group is enabled for AFI/SAFI.
Command
History
neighbor advertisement-interval
c e s
Set the advertisement interval between BGP neighbors or within a BGP peer group.
Syntax
neighbor {ip-address | peer-group-name} advertisement-interval seconds
To return to the default value, use the no neighbor {ip-address | peer-group-name}
advertisement-interval command.
Parameters
Defaults
seconds = 5 seconds (internal peers); seconds = 30 seconds (external peers)
Command Modes
ROUTER BGP
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
(OPTIONAL) Enter the name of the peer group
activate Enter the keyword activate to enable the neighbor/peer group in the new
AFI/SAFI.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to set the advertisement interval for all routers
in the peer group.
seconds
Enter a number as the time interval, in seconds, between BGP advertisements.
Range: 0 to 600 seconds.
Default: 5 seconds for internal BGP peers; 30 seconds for external BGP peers.