348 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Usage
Information
This feature is advertised to BGP neighbors through a capability advertisement. In receiver only mode,
BGP saves the advertised routes of peers that support this capability when they restart.
Command
History
neighbor local-as
c e s
Configure Internal BGP (IBGP) routers to accept external routes from neighbors with a local AS
number in the AS number path
Syntax
neighbor {ip-address | peer-group-name} local-as as-number [no-prepend]
To return to the default value, use the no neighbor {ip-address | peer-group-name} local-as
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Related
Commands
Command
History
neighbor maximum-prefix
c e s
Control the number of network prefixes received.
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum [threshold]
[warning-only]
To return to the default values, use the no neighbor {ip-address | peer-group-name}
maximum-prefix maximum command.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to set the advertisement interval for all routers
in the peer group.
as-number
Enter the AS number to reset all neighbors belonging to that AS.
Range: 0-65535 (2-Byte)
or
1-4294967295 (4-Byte)
or
0.1-65535.65535 (Dotted format)
no prepend Specifies that local AS values are not prepended to announcements from the
neighbor.
bgp four-octet-as-support Enable 4-Byte support for the BGP process.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced command
Introduced support on C-Series
To Next Page
Loading...
