Dell Force10 TeraScale E Series - Page 406

406 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the
Route map used in this command. If you identify a peer by IP address, the Route map overwrites either
the inbound or outbound policies on that peer.
Command
History
neighbor route-reflector-client
c e
t
s
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor ip-address | peer-group-name route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration,
use the no neighbor ip-address | peer-group-name route-reflector-client command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
The first time you enter this command it configures the neighbor as a route reflector and members of
the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you
configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
Command
History
neighbor soft-reconfiguration inbound
c e s
Enable a BGP soft-reconfiguration and start storing updates for inbound IPv4 multicast routes.
Syntax
neighbor {ipv4-address | ipv6-address | peer-group-name} soft-reconfiguration inbound
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series