Dell Force10 TeraScale E Series - Page 488

488 | FTOS Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
Command Modes
CONFIGURATION (conf-frrp)
Command
History
interface
c e
Configure the primary, secondary, and control-vlan interfaces.
Syntax
interface {primary interface secondary interface control-vlan vlan-id}
To return to the default, use the no interface {primary interface secondary interface
control-vlan vlan-id} command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-frrp)
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
primary interface
Enter the keyword primary to configure the primary interface followed by one of
the following interfaces and slot/port information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
secondary
interface
Enter the keyword secondary to configure the secondary interface followed by
one of the following interfaces and slot/port information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
control-vlan
vlan-id
Enter the keyword control-vlan followed by the VLAN ID.
Range: 1 to 4094