Dell Force10 TeraScale E Series - Page 490

490 | FTOS Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
protocol frrp
c e
Enter the Resilient Ring Protocol and designate a ring identification.
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Usage
Information
This command places you into the Resilient Ring Protocol. After executing this command, the
command line prompt changes to conf-frrp.
show frrp
c e
Display the Resilient Ring Protocol configuration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example 1
Figure 18-2. show frrp summary Command Example
ring-id
Enter the ring identification number.
Range: 1 to 255
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
ring-id
Enter the ring identification number.
Range: 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized
version of the Ring configuration.
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
FTOS#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
FTOS#