Dell Force10 TeraScale E Series - Page 518

518 | FTOS Service Agent
www.dell.com | support.dell.com
test-condition (comparing samples)
c e
Configure an action to collect and compare multiple samples of a statistic.
Syntax
test-condition statistic operator sample {cpu | rpm-any} number
Parameters
Defaults
None
Command Mode
CALL-HOME TEST-LIST
Command
History
Usage
Information
FTSA avoids false triggers when a counter rolls over by ignoring the first sample taken after a rollover.
Also, FTSA does not allow you to configure a test that makes no sense because of a comparator that is
out of range. For example, by entering cpu-5-min increase number 150, you would be
looking for a difference between two CPU percentage utilization samples of at least 150. 150 is not
possible, because percentage utilization can only go up to 100, so FTSA displays the acceptable range,
as shown below, and will issue an error message if you try to enter a value that is out of range.
test-condition statistic
Enter the keyword test-condition, followed by one of the following
statistic request types:
•
cpu-1-min: Average CPU utilization for 1 minute
•
cpu-5-min: Average CPU utilization for 5 minutes
•
interface-bit-rate {input | output} slot#: Instantaneous bit rate
on a given line card
•
interface-crc interface: Number of CRC errors on a given interface
•
interface-rate {input | output} interface: Packet rate on a
given interface
•
interface-throttles interface: Number of throttles on an interface
•
memory-free: Free system memory
•
memory-free-percent: Free system memory free in percentage
•
memory-used: System memory used
•
memory-used-percent: System memory used in percentage
•
wred-drops interface: Number of WRED drops on an interface
(E-Series only)
operator Enter one of the following Boolean comparison operators: decrease,
equal-to, greater-than, increase, less-than, not-equal-to,
no-change.
sample number Enter the keyword sample, followed by an integer representing the
number of the sample collected. For example, 5 is the fifth sample collected,
so the first and fifth samples would be compared, using the designated
operator.
Range: 2–100
Default: 2
cpu | rpm-any
Enter the processor that will be tested: cp, lp, rp1, rp2, or test all RPM CPUs
with the keyword
rpm-any.
Version 8.2.1.0
Removed
message-text keyword. Added operators.
Version 7.8.1.0 Introduced on C-Series and E-Series