Dell Force10 TeraScale E Series - Page 548

548 | Internet Group Management Protocol (IGMP)
www.dell.com | support.dell.com
ip igmp group-join-limit
c e s
Use this feature to limit the number of IGMP groups that can be joined in a second.
Syntax
ip igmp group-join-limit number
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-if-interface-slot/port)
Command
History
ip igmp immediate-leave
c e s
Enable IGMP immediate leave.
Syntax
ip igmp immediate-leave [group-list prefix-list-name]
To disable ip igmp immediate leave, use the no ip igmp immediate-leave command.
Parameters
Defaults
Not configured
Command Modes
INTERFACE
Command
History
Usage
Information
Querier normally sends a certain number of group specific queries when a leave message is received,
for a group, prior to deleting a group from the membership database. There may be situations in which
immediate deletion of a group from the membership database is required. This command provides a
way to achieve the immediate deletion. In addition, this command provides a way to enable
immediate-leave processing for specified groups.
number
Enter the number of IGMP groups permitted to join in a second.
Range: 1 to 10000
Version 7.8.1.0 Introduced on C-Series and S-Series
Version 7.6.1.0 Introduced on E-Series
group-list prefix-list-name
Enter the keyword group-list followed by a string up to 16
characters long of the
prefix-list-name.
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
E-Series legacy command