EasyManua.ls Logo

Dell Force10 TeraScale E Series - Page 576

Dell Force10 TeraScale E Series
1640 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
576 | Interfaces
www.dell.com | support.dell.com
Example
Figure 23-9. Bulk Configuration Warning Message
Example
Figure 23-10. Interface Range prompt with Multiple Ports
Example
Figure 23-11. Interface Range prompt Overlapping Port Ranges
Only VLAN and port-channel interfaces created using the interface vlan and interface port-channel
commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or
port-channel interfaces that are not displayed in the show running-config command can not be used
with the bulk configuration feature of the interface range command. You cannot create virtual
interfaces (VLAN, Port-channel) using the interface range command.
The following figure is an example of a single range bulk configuration.
Example
Figure 23-12. Single Range Bulk Configuration
The following figure shows how to use commas to add different interface types to the range enabling
all Gigabit Ethernet interfaces in the range 5/1 to 5/23 and both Ten Gigabit Ethernet interfaces 1/1 and
1/2.
Example
Figure 23-13. Multiple Range Bulk Configuration Gigabit Ethernet and Ten Gigabit
Ethernet
FTOS(conf)#interface range so 2/0 - 1 , te 10/0 , gi 3/0 , fa 0/0
% Warning: Non-existing ports (not configured) are ignored by
interface-range
FTOS(conf)#interface range gi 2/0 - 23 , gi 2/1 - 10
FTOS(conf-if-range-gi-2/0-23#
Note: If a range has VLAN, physical, port-channel, and SONET interfaces, only commands
related to physical interfaces can be bulk configured. To configure commands specific to VLAN,
port-channel or SONET, only those respective interfaces should be configured in a particular
range.
FTOS(conf)#interface range gi 2/1 - 11 , gi 2/1 - 23
FTOS(conf-if-range-gi-2/1-23#
FTOS(config)# interface range gigabitethernet 5/1 - 23
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#
FTOS(config-if)# interface range gigabitethernet 5/1 - 23, tengigabitethernet 1/1 - 2
FTOS(config-if-range)# no shutdown
FTOS(config-if-range)#

Table of Contents

Related product manuals