590 | Interfaces
www.dell.com | support.dell.com
Example
Figure 23-26. show config (Bulk Configuration) Command Example
show interfaces
c e s
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Version 7.5.1.0 Introduced on C-Series
Version 6.1.1.0 Introduced on E-Series
FTOS(conf)#interface range gigabitethernet 1/1 - 2
FTOS(conf-if-range-gi-1/1-2)#show config
!
interface GigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface GigabitEthernet 1/2
no ip address
switchport
no shutdown
FTOS(conf-if-range-gi-1/1-2)#
interface
Enter one of the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number from 0 to
16383.
• For the management interface on an RPM, enter the keyword
ManagementEthernet
followed by the slot/port information. The slot range is 0-1 and the port range is 0.
• For a Null interface, enter the keywords
null 0.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by a number from 1 to 4094.
Version 8.2.1.2 Include SFP and SFP+ optics power detail in E-Series and C-Series output.
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Output expanded to include SFP+ media in C-Series
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
To Next Page
Loading...
