Dell Force10 TeraScale E Series - Page 650

650 | IPv4 Routing
www.dell.com | support.dell.com
ip name-server
c e s
Enter up to 6 IPv4 addresses of name servers. The order you enter the addresses determines the order
of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
Defaults
No name servers are configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all other
interfaces, including the Management port.
You can separately configure both IPv4 and IPv6 domain name servers.
Related
Commands
ip proxy-arp
c e s
Enable Proxy ARP on an interface.
Syntax
ip proxy-arp
To disable Proxy ARP, enter no ip proxy-arp.
Defaults
Enabled.
Command Modes
INTERFACE
Command
History
Related
Commands
ipv4-address
Enter the IPv4 address, in dotted decimal format, of the name server to be used.
ipv4-address2..
. ipv4-address6
(OPTIONAL) Enter up five more IPv4 addresses, in dotted decimal format, of name
servers to be used.
Separate the addresses with a space.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
ipv6 name-server on
page 717
Configure an IPv6 name server.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
show ip interface Displays the interface routing status and configuration.