Dell Force10 TeraScale E Series - Page 653

IPv4 Routing | 653
Related
Commands
ip source-route
c e s
Enable FTOS to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, enter no ip route-source.
Defaults
Enabled.
Command Modes
CONFIGURATION
Command
History
ip unreachables
c e s
Enable the generation of Internet Control Message Protocol (ICMP) unreachable messages.
Syntax
ip unreachables
To disable the generation of ICMP messages, enter no ip unreachables.
Defaults
Disabled
Command Modes
INTERFACE
Command
History
ip vlan-flooding
e
Enable unicast data traffic flooding on VLAN member ports.
Syntax
ip vlan-flooding
To disable, use the no ip vlan-flooding command.
Defaults
disabled
Command Modes
CONFIGURATION
show ip route View the switch routing table.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced on E-Series